Custom Metal Fabrication
We bend it ourselves. On-site, in our own facility, on our own equipment.
Custom Metal Fabrication
Most roofing contractors order their flashing and coping from a supplier. It shows up pre-bent, standard size, and it either fits or it doesn't.
We do it differently. We have our own bending equipment and we fabricate metal components in-house. That means every piece is made for your specific roof: the exact profile, the exact angle, the exact size.
Metal Fabrication
Why It Matters
Roofs aren't always standard. Old houses especially. Angles are off. Edges are irregular. Penetrations are in awkward spots.
When you order off-the-shelf flashing for a non-standard situation, something has to give. Either the metal doesn't fit right, or the installer forces it and hopes for the best. Neither is good.
When we fabricate on-site, we make the metal fit the roof. Not the other way around.
What We Fabricate
- Coping for flat and low-slope roofs
- Custom flashing for chimneys, walls, and penetrations
- Drip edge and rake trim
- Valley metal
- Parapet caps
- Anything else your roof needs that can't be pulled off a shelf
Who This Is For
Commercial jobs with complex details. Older homes with non-standard dimensions. Any project where off-the-shelf just won't cut it.
If another contractor told you your job was too complicated, call us.
Questions People Ask Us (FAQ)
Ready to talk about your project?
Areas we serve
RoofTop Company works across San Luis Obispo County and Santa Barbara County. These are the cities we serve most often.